SUVTP40KH4B4S-APC Smart-UPS VT 40kVA 400V w/4 Batt.
KSh1,500,000.00
In StockSUVTP40KH4B4S-APC Smart-UPS VT 40kVA 400V w/4 Batt.
Product Description
Mod., Start-Up 5X8, Internal Maint Bypass
Parallel Capability 9943 VAH DB-9 RS-232
SmartSlot
SUVTPCOM Multi-function LCD status and control console
Description
SUVTP40KH4B4S-APC Smart-UPS VT 40kVA 400V w/4 Batt.
SUVTP40KH4B4S-APC Smart-UPS VT 40kVA 400V w/4 Batt. Output
Max Configurable Power (Watts)
32.0kWatts / 40.0kVA
Output Voltage Note
Configurable for 380 : 400 or 415 V 3 Phase nominal output voltage
Output Voltage Distortion
Less than 5 % at full load
Output Frequency (sync to mains)
47 – 53 Hz For 50 Hz nominal Sync to mains, 50 Hz +/- 0.1 % For 50 Hz nominal Unsynchronised
Other Output Voltages
380, 415
Load Crest Factor
3 : 1
Topology
Double conversion online
Waveform type
Sine wave
Maximum Output Current
64
Bypass
Built-in maintenance bypass, Built-in static bypass
SUVTP40KH4B4S-APC Smart-UPS VT 40kVA 400V w/4 Batt. Input
Input frequency
40 – 70 Hz Auto-sensing
Input voltage range for main operations
304 – 477V
Other Input Voltages
380, 415
Input Power Factor at Full Load
0.98
Batteries & Runtime
Battery type
VRLA
Included Battery Modules
4
Typical recharge time
5hour(s)
Nominal Battery Voltage
+/- 192 V (split battery referenced to neutral)
Expected Battery Life (years)
3 – 5
RBC Quantity
4
Battery Charge Power (Watts)
1.985kWatts
Extendable Run Time
1
SUVTP40KH4B4S-APC Smart-UPS VT 40kVA 400V w/4 Batt. Battery Volt-Amp-Hour Capacity
9943
Extended Run Options
End of Discharge Battery Voltage
+/- 154 V
Runtime
Efficiency
Communications & Management
Interface Port(s)
DB-9 RS-232, Smart-Slot
Pre-Installed SmartSlot™ Cards
Control panel
Multifunction LCD status and control console
Audible Alarm
Audible and visible alarms prioritized by severity
Emergency Power Off (EPO)
Yes
Physical
Maximum Height
1490MM, 149.0CM
Maximum Width
523MM, 52.3CM
Maximum Depth
842MM, 84.2CM
Net Weight
629.09KG
Shipping weight
660.0KG
Shipping Height
1643MM, 164.3CM
Shipping Width
650MM, 65.0CM
Shipping Depth
1062MM, 106.2CM
Color
Black
Units per Pallet
1.0
Environmental
Operating Temperature
0 – 40 °C
Operating Relative Humidity
0 – 95 %
Operating Elevation
0 – 1015.9meters
Storage Temperature
-50 – 40 °C
Storage Elevation
0 – 15240meters
Audible noise at 1 meter from surface of unit
55.0dBA
Online thermal dissipation
5459.0BTU/hr
Protection Class
IP20
Conformance
Related products
-
APC BX700UI Back-UPS 700VA 230V AVR IEC Sockets UPS
Surge only outletsProtect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage.Battery and surge protected outletsBack up and protect your hardware and data during power outages, surges and spikes.Marketing features
Battery-protected and surge-only outletsReserves power capacity and run time for connected equipment that require UPS battery back-up while providing surge only protection for less critical equipmentKSh9,700.00 -
APC SRV10KIL Easy On-Line SRV Ext. Runtime 10000VA 230V UPS in kenya
-
High quality, Double-conversion On-line UPS designed for essential power protection needs even in the most unstable power conditions
-
Includes: (1) DC cable, Basic UPS signalling RS-232 cable, CD with software, USB cable, User manual
KSh400,000.00 -
-
APC BV1000I-MSX 1000VA Easy Backup UPS
Output power capacity600Watts / 1.0kVANominal Output Voltage230VNominal Input Voltage230VInput ConnectionsBritish BS1363ACord Length1.5metersAPC EASY UPS BV 1000VA, AVR, Universal Outlet, 230VKSh10,600.00 -
APC SMC2000I Smart-UPS C 2000VA LCD 230V UPS
OutputMax Configurable Power (Watts)
1.3kWatts / 2.0kVAOutput Voltage Distortion
Less than 5 % at full loadOutput Frequency (sync to mains)
50 Hz Sync to mainsTopology
Line interactiveWaveform type
Sine waveKSh78,500.00 -
APC Smart-UPS SRT 5000VA 5kva 230V SRT5KXLI
-
10/100 BaseT ConnectionConnect the device to a network using a 10 or 100 BaseT connection
-
Battery failure notificationProvides early-warning fault analysis on batteries enabling timely preventive maintenance
-
Green modePatent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection.
-
LCD graphics displayText and mimic diagrams that display modes of operation, system parameters and alarms.
Smart-UPS On-Line Features & Benefits
Serviceability
-
Audible alarmsProvides notification of changing utility power and UPS power conditions
-
Predicitive failure notificationProvides early-warning fault analysis ensuring proactive component replacement.
-
Disconnected battery notificationWarns when a battery is not available to provide backup power.
-
User-replaceable batteriesIncreases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR)
-
Automatic self-testPeriodic battery self-test ensures early detection of a battery that needs to be replaced.
Adaptability
-
Plug-and-Play external batteriesEnsures clean, uninterrupted power to the loads when adding extra runtime to the UPS.
-
Rack/Tower convertibleProtects the initial investment in the UPS when migrating from tower to rack-mount environment.
-
Flash upgradeable firmwareInstall maintenance releases of firmware remotely using FTP.
Manageability
-
LED status indicatorsQuickly understand unit and power status with visual indicators.
-
Serial connectivityProvides management of the UPS via a serial port.
-
Network manageableProvides remote power management of the UPS over the network.
-
InfraStruXure Manager CompatibleEnables centralized management via the APC InfraStruXure Manager.
-
SmartSlotCustomize UPS capabilities with management cards.
Protection
-
Frequency and voltage regulationGives higher application availability by correcting poor frequency and voltage conditions without using the battery.
-
Power conditioningProtects connected loads from surges, spikes, lightning, and other power disturbances.
-
Input power factor correctionMinimizes installation costs by enabling the use of smaller generators and cabling.
-
Generator compatibleEnsures clean, uninterrupted power to protected equipment when generator power is used.
-
Cold-start capableProvides temporary battery power when the utility power is out.
-
Resettable circuit breakerEasy recovery from overloads; no need to replace a fuse.
-
Safety-agency approvedEnsures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.
Availability
-
Scalable runtimeAllows additional run time to be quickly added as needed.
-
Intelligent battery managementMaximizes battery performance, life, and reliability through intelligent, precision charging.
-
Hot-swappable batteriesEnsures clean, uninterrupted power to protected equipment while batteries are being replaced
-
Automatic restart of loads after UPS shutdownAutomatically starts up the connected equipment upon the return of utility power.
-
Temperature-compensated battery chargingProlongs battery life by regulating the charge voltage according to battery temperature.
-
Automatic internal bypassSupplies utility power to the connected loads in the event of a UPS power overload or fault.
Marketing Features
-
Low operating and maintenance costs with proven reliability and intelligent battery management.Intelligent battery management, pioneered by APC, maximizes battery performance and life through intelligent, precision temperature compensated charging. Automatic self tests insure battery reliability and warn customers in advance of battery replacement. Convenient, easy to connect, hot-swappable battery modules provide battery replacement without powering down.
-
Save time with easy and convenient remote/network accessibility.Network manageable via serial, USB or Ethernet. Includes Powerchute® Software for convenient monitoring and control, safe operating system shutdown, and innovative energy management capabilities.
-
Peace of mind that comes with full equipment compatibility and reliability of a leaderProvides pure sine wave output which is recommended by server manufacturers using active power factor corrected (PFC) power supplies. Safety agency tested and approved means that you can deploy Smart-UPS with confidence that they meet or exceed the industry’s most rigorous standards.
-
Avoids costly power problems by keeping your IT equipment and data protected and available.Network grade power conditioning protects from damaging surges and disruptive noise. The double conversion architecture provides tight voltage regulation, frequency regulation ,and zero transfer time to battery during power events.
Print Technical Specification
” width=”12px” height=”14px” data-src=”https://www.apc.com/static/images/print_pdf.png” />
Output
-
Output power capacity
4.5 KWatts / 5.0 kVA
-
Max Configurable Power (Watts)
4.5 KWatts / 5.0 kVA
-
Nominal Output Voltage
230V
-
Output Voltage Distortion
Less than 2%
-
Output Frequency (sync to mains)
50/60Hz +/- 3 Hz
-
Other Output Voltages
220, 240
-
Load Crest Factor
3 : 1
-
Topology
Double Conversion Online
-
Waveform type
Sine wave
-
Output Connections(6) IEC 320 C13 (Battery Backup)(2) IEC Jumpers (Battery Backup)(4) IEC 320 C19 (Battery Backup)
-
Bypass
Internal Bypass (Automatic and Manual)
Input
-
Nominal Input Voltage
230V
-
Input frequency
40 – 70 Hz (auto sensing)
-
Input Connections
Hard Wire 3 wire (1PH+N+G)
-
Input voltage range for main operations
160 – 275V
-
Input voltage adjustable range for mains operation
100 – 275 (half load)V
-
Other Input Voltages
220, 240
Batteries & Runtime
-
Battery type
Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
-
Included Battery Modules
2
-
Typical recharge time
1.5hour(s)
-
Nominal Battery Voltage
192V
-
Replacement Battery
-
Expected Battery Life (years)
3 – 5
-
RBC Quantity
1
-
Extendable Run Time
1
-
Extended Run Options
-
Runtime
-
Efficiency
Communications & Management
-
Interface Port(s)
RJ-45 10/100 Base-T , RJ-45 Serial , Smart-Slot , USB
-
Control panel
Multi-function LCD status and control console
-
Audible Alarm
Audible and visible alarms prioritized by severity
-
Emergency Power Off (EPO)
Yes
-
Available SmartSlot™ Interface Quantity
1
Surge Protection and Filtering
-
Surge energy rating
480Joules
Physical
-
Maximum Height
432mm , 43.2CM
-
Maximum Width
130mm , 13.0CM
-
Maximum Depth
719mm , 71.94CM
-
Net Weight
54.43KG
-
Shipping weight
63.6KG
-
Shipping Height
330mm , 33.0CM
-
Shipping Width
610mm , 61.0CM
-
Shipping Depth
960mm , 96.0CM
-
Color
Black
-
Units per Pallet
6.0
Environmental
-
Operating Temperature
0 – 40 °C
-
Operating Relative Humidity
0 – 95% non-condensing %
-
Operating Elevation
0-3000meters
-
Storage Temperature
-15 – 45 °C
-
Storage Relative Humidity
0 – 95% non-condensing %
-
Storage Elevation
0-15000meters
-
Audible noise at 1 meter from surface of unit
55.0dBA
-
Online thermal dissipation
931.0BTU/hr
-
Protection Class
IP 20
Conformance
-
Approvals
CE, CE Mark, EAC, EN/IEC 62040-1, EN/IEC 62040-2, IRAM, RCM, VDE
KSh305,000.00 -
-
APC Back-UPS 1400VA (BX1400U-MS) 230V
- Automatic Voltage Regulation (AVR)
- Resettable circuit breaker
- Telephone dataline surge protection
- Battery-protected and surge-only outlets
KSh27,500.00
Reviews
There are no reviews yet.