Grundfos CU 200 SQFlex Control Unit
KSh57,954.00
In StockBuy Grundfos CU 200 SQFlex Control Unit from Pavuta Telecoms the leading Grundfos dealer in Kenya, Nairobi at a very discounted price
Description
Grundfos CU 200 SQFlex Control Unit
For use with utility power or sine wave inverters for AC, or series PV arrays for DC.
A user-friendly interface box that maintains two-way communication with the pump and monitors the operating conditions. Built-in diagnostics indicate faults and dry-running, operating status power consumption, and level switch input. Built-in system monitor display shows pump operation, full tank, input power (watts), Alarm indicator for a dry run, overvoltage, overload, and overtemperature.
The CU 200 control unit is a combined status, control, and communication unit specially developed for the SQFlex system. Furthermore, the CU 200 enables the connection of a level switch. May be used with the IO-100 and/or IO-102.
The CU 200 incorporates cable entries for:
- power supply connection (pos. 6)
- pump connection (pos. 7)
- earth connection (pos. 8)
- level switch connection (pos. 9).
Communication between the CU 200 and the pump takes place via the pump power supply cable. This is called mains borne signaling (or Power Line Communication), and this principle means that no extra cables between the CU 200 and the pump are required. It is possible to start, stop, and reset the pump by means of the on/off button.
The CU 200 controller and system monitor can be used with solar alone or in combination with the IO101 (for manual generator backup). The CU200 will allow you to add a float switch to shut off the pump when the storage tank is full. The system monitor display on the CU200 shows the following:
* Pump operation
* Full Tank
* Input Power (Watts)
* Alarm Indicator for dry running, over-voltage, overload and over-temperature.
Grundfos CU 200 SQFlex Control Unit operation of the pump to be monitored:
– Water reservoir is full (level switch)
– Pump is running
– Input power
The CU 200 offers the following alarm indications:
– Dry running
– Service needed in case of:
—- no contact to pump
—- overvoltage
—- overtemperature
—- overload
In addition, the CU 200 shows the symbols of the energy supply options
Developed for the SQFlex water supply systems, the CU 200 SQFlex control unit offers:
– system monitoring on the basis of sensor signals
– system control on the basis of sensor signals
– monitoring of operation and alarm indication
Technical data
– Voltage: 30-300V DC or 90-240 V AC (50/60 Hz)
– Enclosure class: IP55
– Current consumption :130 mA
Weight:Â 1.9 Kilograms
Warranty:Â 2yrs
Reviews
There are no reviews yet.